|
|
Build Your Online Product Catalogs?
| Product Name: |
FMVSS 302 Flammability test to Motor Vehicle Inte
|
| Supply Ability: |
|
| Related proudcts |
flammability test, fmvss 302, motor vehicle inter, |
| Specifications |
FMVSS 302 |
| Price Term: |
|
| Port of loading: |
|
| Minimum Order |
|
| Unit Price: |
|
|
FMVSS 302 Flammability test to Motor Vehicle Interior materials
Ecosafene have rich experience to provide FMVSS 302 Flammability test to Motor Vehicle Interior materials.
FMVSS 302: Federal Motor Vehicle Safety Standard 302
FMVSS302 Flammability of Interior materials
FMVSS 302 Scopeï¼?
This standard specifies burn resistance requirements for materials used in the occupant co***rtments of motor vehicles
FMVSS 302 Purpose.ï¼?
The purpose of this standard is to reduce the deaths and injuries to motor vehicle occupants caused by vehicle fires, especially those originating in the interior of the vehicle from sources such as matches or cigarettes.
FMVSS 302 Applicationï¼?
This standard applies to passenger cars, multipurpose passenger vehicles, trucks, and buses.
FMVSS 302 Test Procedureï¼?
a. Mount the specimen so that both sides and one end are held by the U-shaped frame, and one end is even with the open end of the frame. Where the maximum available width of a specimen is not more than 51 mm, so that the sides of the specimen cannot be held in the U-shaped frame, place the specimen in position on wire supports as described in S5.1.3, with one end held by the closed end of the U-shaped frame.
b. Place the mounted specimen in a horizontal position, in the center of the cabinet.
c. With the flame adjusted according to S5.1.4, position the bunsen burner and specimen so that the center of the burner tip is 19 mm below the center of the bottom edge of the open end of the specimen.
d. Expose the specimen to the flame for 15 seconds.
e. Begin timing (without reference to the period of application of the burner flame) when the flame from the burning specimen reaches a point 38 mm from the open end of the specimen.
f. Measure the time that it takes the flame to progress to a point 38 mm from the clamped end of the specimen. If the flame does not reach the specified end point, time its progress to the point where flaming stops.
g. Calculate t |
| Company: |
Xiamen Ecosafene Product Technical Service Co.,Ltd
|
| Contact: |
Ms. Anne Lin |
| Address: |
1812 Gangmao Mansion, No.22 Xingqian Road, Jimei,Xiamen 361022, China |
| Postcode: |
|
| Tel: |
86-0592-5056211 |
| Fax: |
86-0592-5105807 |
| E-mail: |
|
|
|
|
Home
